| | |
|
|
|
|
The 105 foot tower with many beams on it. Bottom up: Telrex 5 element 20 at 45 feet, 4 element 15 at 72 feet, 5 element 10 at 76 feet and a 5 element 6 at 80 feet (those last 3 turn 300 degrees on a side arm). A 3 element 20 with a skewed reflector pointing at KL7, a 3 element 40 at 115 feet, a 2M18XXX at 110 feet and a 6 element 6 at 115 feet. There are a couple of 1296 loopers on the mast also. Viewed: 109 times.
|
A 5 element 10 laying on the ground and some VHF antennas. Viewed: 93 times.
|
Just to the left of my SW 80 meter vertical, you can see the wire element for the SW 160 meter element. It is strung between the driven element (72 foot tower to the right) and the 105 foot tower. Viewed: 89 times.
|
| | |
| | |
|
|
|
|
This is the NE 80 meter 4 square vertical - with the extension to put a pulley at 80 feet so I can suspend a wire element for 160. Viewed: 99 times.
|
This is the SW base of the 80 meter 4 square and 160 meter array. I put an SO239 in series with the 160 meter element and the plug in coils allow me to tune the array. You can see various inductors scattered around with PL259s on them. Viewed: 135 times.
|
This shows the two relays and the inductor used to change a director into a reflector. Viewed: 124 times.
|
| | |
| | |
|
|
|
|
The gamma match cap for the driven element. Viewed: 110 times.
|
The bottom of the gamma match on the driven element. Viewed: 108 times.
|
The base of the NE 80 meter vertical and 160 element. There is a two turn inductor in the SO239. Viewed: 121 times.
|
| | |
1
