[DEMI] 432-28

[George Fremin III - K5TR]

I built an IF switch over the last week or so
and as part of this project have been adding a 
way to turn the RX section off on my DEM transverters.

I did this to the 144-28 and the 222-28 - both of these 
had pads and markings on the board that were makred
RXON so it was quite easy to find the point to remove 
power from and just what I needed to switch.

I just opened up my 432 transverter and I do not 
see this on the board (unless I am getting tired) and I 
do not seem to have a manual for this unit. 

Any hints or suggestions on how I can turn 
the receiver off but leave the LO on?

I just looked at it again - and I think I see one
wire that looks promising but I dont have the
the manual so I am flying a bit blind.


-- 
George Fremin III - K5TR
geoiii@kkn.net
http://www.kkn.net/~k5tr