[DEMI] DEM 222-28 assembly problems

[Jeffrey C. Rowsey - WB5YWI]

I was planning on spending my holiday time off assembling my christmas
present to myself, a DEM 222-28 transverter kit.  However, the board and
the diagram included in the instructions aren't matching up.  I first
noticed it when putting components on the bottom of the board.  Now I'm
3 parts into the top of the board and having problems.  After trying  to
find the spot for a chip capacitor without any luck, I tried to see if
the spots for the relays were correct.   Well, neither relay K1 or K 2
fits in a spot even close to where the diagram says they should be.  As
a matter of fact, I can't find a spot for them at all.

On the top of the board the spots for 13.8vdc and "ant" are not the same
as the diagram.  I could go on.

I'm thinking I either got the wrong board, or there has been revisions
and either the board or the diagram is an earlier version.  Has anyone
else noticed these problems?  I assembled a TIB and didn't have any
problems.  However, that was a much simpler kit.

I hope someone out there can help.  DEM is closed until after the 1st
and I'd really like to work on this kit.

TIA  & 73,

Jeff WB5YWI

--
EM25gs
Bands: 6,2,432,1296
Web Page:  http://www.azalea.net/~wb5ywi