|
|
The phono jacks I used. You typically need to trim the center pin so that it doesn't short to the antenna tuner when you reinst
Date: 01/04/2000
Views: 2004
|
|
|
|
The two coaxs soldered to the phono jacks. I probably would have been smarter to face the ground lugs on the other side of the
Date: 01/04/2000
Views: 1973
|
|
|
|
Looking at the screw hole. This is enough clearance for the screwdrive to work.
Date: 01/04/2000
Views: 1961
|
|
|
|
The antenna tuner reinsalled and cables hooked up.
Date: 01/04/2000
Views: 2257
|
|
|
|
The front of the antenna tuner hooked up.
Date: 01/04/2000
Views: 2046
|
|
|
|
The top cover over the filter board. It is easy to think this should be installed upside down.
Date: 01/04/2000
Views: 1933
|
|
|
|
The second modification makes the CW sidetone level get adjusted with the monitor level control on the front panel. The yellow
Date: 01/04/2000
Views: 2014
|
|
|
|
Note that the small resistor is now gone. Be careful when getting the soldering iron down there, there are lots of cables aroun
Date: 01/04/2000
Views: 1776
|
|
|
|
Just to the left of the sidetone monitor control, you will find IC7. You will need to make a connection to pin 2 of the IC. I
Date: 01/04/2000
Views: 1939
|
|
|
|
You will need to create a series combination of a resistor (about 100K Ohms) and a capacitor (about .001 uf). Values are not cr
Date: 01/04/2000
Views: 2473
|
|
